CMDSTATUS=Val_0x0
Device Generic Command Register
| CMDTYP | Generic Command Type. Specifies the type of generic command the software driver is requesting the controller to perform. 2 (Val_0x2): Set Periodic Parameters 4 (Val_0x4): Set Scratchpad Buffer Array Address Lo 5 (Val_0x5): Set Scratchpad Buffer Array Address Hi 7 (Val_0x7): Transmit Device Notification 9 (Val_0x9): Selected FIFO Flush 10 (Val_0xA): All FIFO Flush 12 (Val_0xC): Set Endpoint NRDY 16 (Val_0x10): Run SoC Bus LoopBack Test 17 (Val_0x11): Restart After Disconnect |
| CMDIOC | Command Interrupt on Complete. When this bit is set, the device controller issues a Generic Command Completion event after executing the command. Note that this interrupt is mapped to the DCFG[INTRNUM] bit field. Note: This field must not set to 0x0 if the DCTL[RUN_STOP] bit is set to 0x0. |
| CMDACT | Command Active. The software sets this bit to 0x1 to enable the device controller to execute the generic command. The device controller sets this bit to 0x0 after executing the command. |
| CMDSTATUS | Command Status. 0 (Val_0x0): Indicates command success 1 (Val_0x1): Indicates that the device controller encountered an error while processing the command. |